Tap Favourites Wi-Fi Settings Advanced networking.Make sure that your mobile device is still connected to your Nest Wifi or Google Wifi network. To do this, disconnect the Ethernet cable from your router or primary Wifi point and wait until the light pulses yellow for Google Nest Wifi or pulses orange for Google Wifi. To change your WAN settings, Nest Wifi or Google Wifi must be offline and your mobile phone must be connected to your Nest Wifi or Google Wifi network. In WAN settings, you can view your WAN IP address and configure settings using one of the connection methods below: The type of WAN connection that you have is usually determined by your Internet Service Provider (ISP). Check with your ISP if you have questions about which settings to use. But if it is causing problems, it's recommended to put your third-party router in bridge mode and turn off Wi-Fi on your third-party router to avoid interference.Wide area network (WAN) settings let you control how Google Nest Wifi and Google Wifi connect to the Internet. With this configuration, you may run into Double NAT, which isn't necessarily a problem. When finished, set up your Nest Wifi or Google Wifi devices in the Google Home app.Connect the third-party router to the Nest Wifi router or primary Wifi point's WAN port with an Ethernet cable.Connect your modem’s LAN port to the third-party router’s WAN port with an Ethernet cable.If you have a router already connected that supports VLAN tagging, you can add your Google Nest Wifi router or Google Wifi primary point to it. When finished, set up your Google Nest Wifi or Google Wifi in the Google Home app.Connect the switch’s LAN port to your Google Nest Wifi router’s or Google Wifi primary point’s WAN port with an Ethernet cable.Connect your modem’s LAN port to the switch’s WAN port with an Ethernet cable.Use a managed network switchĪdd a separate managed network switch (sometimes called a "smart network switch") with VLAN features. This will allow you to set up your Nest Wifi router or Google Wifi primary point again in the future without additional equipment. Note: If your ISP uses a Google supported tag, and you temporarily use a VLAN-supported router, then once your network is set up and online, Nest Wifi and Google Wifi devices will be able to download an update that allows it to support VLAN tagging. When VLAN tagging is required by your ISP, for some Nest Wifi and Google Wifi devices to work, you'll need to add a switch to your network or use an additional VLAN-supported router. Use Nest Wifi or Google Wifi with a VLAN-tagged broadband connection If it does, and it isn’t a Google-supported tag follow the instructions below. To confirm if your ISP uses VLAN tagging, or if you have IPTV or VoIP service through your ISP, ask your ISP if your CPE box (ISP provided modem or router) requires a VLAN tag. To determine the proper tag required, check with your ISP or your modem’s manual. If your ISP requires a different tag, your setup will require an additional device for it to work. Google supports VLAN tag values of 2, 7, and 10 (from a possible range of 0 to 4095). For these, you’ll need additional equipment to support VLAN tagging or your setup will fail. However, some devices with older firmware don't support VLAN tagging out of the box. Nest Wifi and Google Wifi devices built or updated after June 2020, automatically support some VLAN tags and additional steps aren’t usually needed to set up a network. Some Internet Service Providers (ISP) require VLAN tagging in order for their modems to communicate with wireless routers.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |